Microsens 10/100Base-TX to 100Base-FX Manual do Utilizador descarregar pdf (Página 6)

Bridge Module 10/100Base-TX/100Base-FX Page 6/7

MICROSENS GmbH & Co. KG - Küferstr. 16 - D-59067 Hamm - Tel. +49 (0)2381/9452-0 - Fax -100 - www.microsens.com

7 – 9 Off

10 ON: Configuration by Management

11 Off

12 Off

Additional the bandwidth of the user data can be limited symmetric. By the software

management it is possible to limit the bandwidth in steps of 32 kbps or by the DIP-

switches in the following steps:

DIP-switch

7 8 9

Max. data rate between the ports (each direction)

0 0 0 100 Mbps (100Base-TX), no limitation

0 0 1 75 Mbps

0 1 0 50 Mbps

0 1 1 34 Mbps (E3)

1 0 0 20 Mbps

1 0 1 10 Mbps (10Base-T)

1 1 0 8 Mbps

1 1 1 2 Mbps (E1)

0 = Switch OFF, 1 = Switch ON

Link Trough / ALM

The link status of each segment is forwarded, that means a missing link on the input

side also the link signal of the corresponding output side is switched off physically.

Attention: If activated by the DIP-switches there is no link signal generated by the

bridge in idle state. This is no malfunction!

Port x Port x

RX RXTX TX

TX TXRX RX

Port y Port y

No Link Link

Link Thr ough ON Link Through OFF

If ALM (Advanced Link Monitoring) is activated the same fiber port is not sending a link

signal if he does not receive a link signal (Link Down). This ensures that both directions

of the fiber line, TX and RX are having the same link status.

Por t x Port x

TX TX

RX RX

Port y Po rt y

No Link Link

ALM ON ALM OFF

1 2 3 4 5 6 7

Sem comentários

Microsens 10/100Base-TX to 100Base-FX Manual do Utilizador Página 6