Microsens RS232 Especificações descarregar pdf (Página 16)

4 Port Industrial Device Server Manual page 16/36

MICROSENS GmbH & Co. KG - Küferstraße 16 - 59067 Hamm - Tel. +49 2381/9452 0 - Fax 9452 100 - www.microsens.com

Configure serial port

Serial Settings

The following table describes the labels in this screen.

Label

Description

Port Alias

Remark the port to hint the connected device.

Interface

RS232 / RS422 / RS485(2-wires) / RS485(4-wires)

Baud rate

110bps/300bps/1200bps/2400bps/4800bps/9600bps/19200bps/

38400bps/57600bps/115200bps/230400bps/460800bps

Data Bits

5, 6, 7, 8

Stop Bits

1, 2 (1.5)

Parity

No, Even, Odd, Mark, Space

Flow Control

No, XON/XOFF, RTS/CTS, DTR/DSR

Performance

Throughput: This mode optimized for highest transmission speed.

Latency: This mode optimized for shortest response time.

Serial to

Ethernet

Delimiter:

You can define max. 4 delimiters (00~FF, Hex) for each way. The data will be

hold until the delimiters are received or the option “Flush Serial to Ethernet

data buffer” times out. 0 means disable. Factory default is 0.

Flush Data Buffer After:

The received data will be queuing in the buffer until all the delimiters are

matched. When the buffer is full (4K Bytes) or after "flush S2E data buffer"

timeout the data will also be sent. You can set the time from 0 to 65535

seconds.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Sem comentários

Microsens RS232 Especificações Página 16