Microsens RS485 Manual do Utilizador descarregar pdf (Página 26)

MICROSENS User Manual Device Server RS-232/422/485 Port to 1x or 2x 10/100TX

and Device Server RS-232/422/485 Port to 1x 100FX

Time:

 SNTP: Enable or disable SNTP function to get the time from the SNTP

server.

 Time Zone: Set the local time zone of the device server.

 Local Time: Set the current time of the device server.

 Time Server: The location and port of the time server.

Console:

 Telnet Console: Enable or disable the telnet console.

IP Configuration

This page allows user to set the related configuration of the device server in

network.

IP Configuration: Select the assigning solution of IP configuration which is

assigned by DHCP/BOOTP or Static.

IP Address: Assign the IP address that the network is using.

Netmask: Assign the subnet mask of the IP address.

Gateway: Assign the network gateway for the device server. The default

gateway is 192.168.16.1.

DNS Server1: Assign the primary DNS IP address.

DNS Server2: Assign the secondary DNS IP address.

Auto IP Report

 Auto Report to IP: Assign an IP to report the final alive check.

 Auto Report to TCP Port: Assign the port number.

 Auto Report Interval: Set the interval period for Auto report.

Ethernet Mode

 Ethernet mode: The 1 RS-232/422/485 port to 2 10/100TX Device Server

supports the choice of RJ-45 ports for being used as a pair of redundant

port. If you mark the radio group item of “Redundant”, only one of the

two RJ-45 ports is active. When the active RJ-45 port fails, the other one

will be active to take over the work. While you mark the radio group

item of “Switch”, the two RJ-45 ports are used as general switching

ports.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 43 44

Sem comentários

Microsens RS485 Manual do Utilizador Página 26